Black jack fibered roof & foundation coating. BlackJack Gardner – Roof&Foundation Coating
The GHS is a system for standardizing and harmonizing the classification and labelling of chemicals.
About Roof / Foundation Coatings
Jaco Waterproofing A coating on the exterior of a foundation wall prevents water and water vapor from moving through the wall. The GHS classifications for chemicals associated with products in this database may be viewed by selecting the "Advanced" button on the Chemical Ingredients tables.
CAS numbers identify the chemical, but not its concentration or specific mixture. Since the reaction is driven by water, the crystals will actually grow denser in the wetter areas and can even self seal small cracks. Most waterproofing is an exterior coating, on the positive side exterior of the wall, although another option is to use an admixture that makes the concrete itself impervious to water and water vapor see Integral Waterproofing.
This approach has proven very successful, especially in difficult waterproofing situations. New concrete should be allowed to cure and dry out for 7 to 14 days, although some spray-on membranes can be applied to green concrete.
Shop by category
Loose particles should be washed or brushed off, protrusions removed, black jack fibered roof & foundation coating any existing cracks repaired. Since this is a work in progress, GHS classifications may not be shown for all chemical ingredients.
A low water-cement ratio mix will have less shrinkage that can lead to leaky cracks. These coatings dry in about 60 minutes to form a seamless barrier which is resistant to puncture. One method employs sheets fastened to the wall and lapped adequately at seams, both vertical and horizontal.
Items in search results
Walls should be reinforced to keep cracks tight and the concrete should be well consolidated. Integral Waterproofing Another waterproofing option for concrete walls is integral waterproofing in the concrete itself.
For retrofit projects or if there are larger cracks, this material can also be applied as a cementitious overlay to the outside of a concrete wall.
Adequate lapping at seams, 2 to 3 inches, is important and be careful to prevent gaps or "fish mouths" at the edges. This clay is highly expansive and when water makes contact it forms an impenetrable barrier against infiltration. The International Residential Code specifies that the membrane must extend from the top of the footing to the finished grade, but a better approach is to take the membrane over the footing and down into the drain trench.
Chemicals are associated with codes that define their health, physical and environmental hazards. The outside of the wall is covered with an impermeable coating that extends down to the drain.
Percent of chemical in preparation. This universal hazard communication system was developed to ensure that employers, employees and consumers are provided with adequate, practical, reliable and comprehensible information on the hazards of chemicals, so that they can take effective preventive and protective measure for their own health and safety.
For bubbled areas, slit the membrane, press it down, and apply a patch of membrane right over the top. The sheets can be cut with a razor and pressed down to seal.
Crystalline waterproofing can be applied to the inside negative side of a wall and still seal out water. Another way to waterproof is to apply sheet products, typically rubberized asphaltic membranes attached to polyethylene film.
Some of the spray-on treatments require a priming coat and then one or more final layers of a liquid-rubber, elastomeric coating built up to usually a minimum mil thickness. Click on each chemical for information on chemical structure, properties and health effects. Dampproofing is a relatively simple treatment of asphaltic material that is sprayed on or applied with brush or roller.
Chemical Chemical Abstracts Service Registry Number is a unique identifier for a chemical and its synonyms.
Research Decorative Concrete
For very wet foundations, a waterproofing contractor might use bentonite waterproofing panels. Seam tape can be used to bridge cracks. These panels are made of bentonite clay sandwiched between cardboard.
All waterproofing and dampproofing starts with a clean, smooth wall surface.